Table of Contents
Advertisement
20) Scale (FD)
Requirement
Adjust so that the leading edge of the image of the scale on the copy sample falls within the
specified range with respect to the Original Length Scale.
Specification
0 ± 0.5 mm
NOTES
1) This adjustment must be made when the Scanner has been removed or the Scanner Drive Cable
or Original Glass has been replaced.
2) After the adjustment, be sure to return Erasure Width, Registration and Lead Edge Erase on the
printer side to the original values.
Adjustment Procedure
2. Set Erasure Width to 0. (See p. D-102 for the erase width setting procedure.)
3. Set the registration of one paper source of Registration (FD) on the printer side to +5.0. (See p. D-92
for the registration setting procedure.)
NOTE
If the total value of the settings made of the paper source, Duplex, and 600 dpi on "Registration
(FD)" of "Printer" available from "Adjust" is +10 or more, malfunction code C13F4 can at times be
4. Set Lead Edge Erase on the printer side to 0. (See p. D-94 for the erase width setting procedure.)
5. Touch [END] and press the Interrupt key to set the copier into a test print mode.
6. Press the Start key to make a copy.
8. Call the Adjust mode to the screen.
9. Touch the [IR] Key to highlight "Scale (FD)".
Adjust Mode
Scale (FD)
1. Place a scale on the Original Glass so that it runs parallel
with the Original Length Scale and its leading edge is
aligned with the Original Width Scale.
1155D166AA
7. Check to see if the leading edge position of the image of
the scale on the copy falls within the specifications with
respect to the Original Length Scale.
If it is outside the specified range, perform the following
adjustment steps.
1155D167AA
D-110
Setting Range
-12.0 to +12.0
Advertisement
Chapters
Table of Contents
