Table of Contents
Advertisement
1155SBS050411A
11) Finisher
Touch Panel Display
Finisher
I/O Check
Sensors
Port Signal
Tech. Rep. Choice
Fold-Stopper
Staple (Edge)
Staple (Center)
Z-Fold Paper
Fin. Warning Off
Tech. Rep. Mode
Setting (The default is
This function allows the Tech. Rep. to make the various choice settings
and sensor checks as they relate to the Finisher.
Checks the sensors of the Finisher and indicates the state of each sensor
with either 0 or 1.
<Procedure>
1. With the I/O Check screen on the Touch Panel, directly activate or deac-
tivate each sensor.
2. The copier shows either 1 or 0 on a realtime basis.
Displays the details of the input to each sensor of the Finisher.
Displays the input states of all input ports of the Finisher except the paper
passage sensor.
Allows the Tech. Rep. to set, check, adjust, and program the various Tech.
Rep. functions for the Finisher.
Adjust the stop position of the 1st Crease Stopper.
Note: In the Inch Areas, this function cannot be used because the 1st
Crease Stopper has a different mechanism.
Set the leading edge stapling position in the FD direction.
Set the center stapling position in the FD direction.
Set the number of unfolded and Z-folded sheets of paper to be stored in
the Z-Folding Processing Tray.
<No. of unfolded sheets of paper>
<No. of Z-folded sheets of paper>
Select whether to turn Enable or Disable the warnings as they relate to the
Finisher (remove copies warning for the Non-Sort Tray and Elevator Tray).
Enable
S-49
Finisher
Highlighted
(−5 to +5)
(0)
(−7 to +7)
(0)
(−5 to +5)
(0)
(0 to 50)
(0 sheets)
(0 to 10)
(0 sheets)
.)
Disable
Advertisement
Chapters
Table of Contents
