Zoom (Cd - Minolta Di 620 Manual

Hide thumbs Also See for Di 620:

Table of Contents

17) Zoom (CD)

Requirements

1) The difference should be within ± 0.5% of the actual length.

2) Adjust so that the following specifications are satisfied with a scale length of 200 mm.

Full size (×1.000)

This adjustment must be made when the CCD Unit has been replaced.

Adjustment Procedure

3. Call the Adjust mode to the screen.

4. Touch the [IR] key to highlight "Zoom (CD)".

Specification

200 ± 1.0 mm

1. Place a scale in parallel with the Original Width Scale and

make a copy.

* Use the full size (×1.000) mode and 200-mm-or-wider pa-

* If the scale is of plastic and transparent, place a blank

2. Measure the length of the scale on the copy to find the

* If the difference is outside the specification, adjust by fol-

sheet of paper over it.

lowing the procedure shown below.

Setting Range

0.990 to 1.010

Table of Contents