5) AIDC Sensor Adjustment (F5 Mode)
When is this adjustment required?
• Be sure to perform the AIDC Adjustment (F5 mode) after the following items have been done.
1) Starter replacement
2) AIDC Sensor replacement
3) Memory clear
NOTE
This adjustment must be made after F8 ATDC Sensor Adjustment.
Adjustment Procedure
1. Turn the Power Switch ON.
2. Call the Tech. Rep. mode menu to the screen.
3. Touch [Function] and [Printer], in that order.
4. Touch [F5 AIDC Sensor Adjustment].
5. Press the Start Key to let the copier make the AIDC Sensor adjustment. (It will run for about 3
minutes.)
NOTE
While the copier is in the adjustment cycle, the Start Key is lit up orange. The key turns green as
soon as the adjustment cycle is completed.
6. After the adjustment, touch [End] and then [Menu] to recall the Tech. Rep. mode to the screen.
D-86