Flash Memory - Minolta Di 620 Manual

Hide thumbs Also See for Di 620:

Table of Contents

1155SBM2400A

FLASH MEMORY

The conventional system software has been upgraded by replacing the ROMs on

each printed wiring board. This copier employs a flash memory for its system con-

trol IC mounted on Memory Board. Data can be easily rewritten by following the

steps given below using the IC card (memory card) in which data has previously

been recorded.

1. Unplug the power cord from the power outlet and remove the Upper Right Cover.

2. Insert the memory card into the specified position on PWB-B.

5. On the Touch Panel, make sure that the data has been prop-

erly written. Then, unplug the power cord from the power outlet

* Do not turn S1 OFF at this time.

NEVER attempt to remove or insert the memory card with the copier turned ON.

3. Plug the power cord into the power outlet.

4. Turn ON Power Switch S1.

* This rewrites the data.

6. Remove the memory card.

Memory Board (PWB-B)

Table of Contents