Energy Saver Mode; Job Memory - Minolta EP2051 Operator's Manual

Energy Saver Mode

Instead of turning the copier OFF, it's a good
idea to use the Energy Saver Mode. This mode
will minimize the time for the copier to
complete the warm-up cycle to about 20 sec.
The Energy Saver Mode is automatically
activated a given period of time after the
copier has been used last.
The initial setting is 15 min.
Pressing the Energy Saving Key sets the
copier into the Energy Saver Mode.
To cancel the Energy Saver Mode, press any
key on the Control Panel, for instance, the
Start Key.
Useful Tip
The time for the copier to enter the Energy
Saver Mode can be selected from 1 to 98
min, or for 120 min. by using User's
Choice. p. 5
NOTE
The copier is shut down if the Auto Shut
OFF function activates while the copier is
in the Energy Saver Mode.

Job Memory

One copying job program that is
frequently used can be stored in memory
and called up later as necessary.
Job Memory Setting
Press the job Memory Input Key.
1
* The Job Memory Indicator Starts
blinking.
Make the control panel settings for the
2
job to be stored in job memory.
Press the Job Memory Select Key.
3
* The Job Memory Indicator lights
up and the copying job program has
been stored in job memory.
Job
Memory
To call up the job program from
memory, press the Job Memory Selec
Key.
NOTE
If you have stored a wrong job
program or if you want t
replace an old job program with
a new one, perform steps 1, 2,
and 3.
17
5. Auxiliary Functions
Job
Memory
Input
1139O8032A
1139O2572A