Removing The Power Tilt Unit; Removing The Clamp Bracket - SELVA MARINE Wahoo 15 Service Manual

BRKT

Removing the power tilt unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power tilt unit should
lose fluid pressure.
NOTE:
If the power tilt unit does not operate, open
the manual valve by turning it counterclock-
wise, and then tilt the outboard motor up
manually.
2. Remove the plastic tie 1 from the clamp
bracket 2, and then pull out the power
tilt motor lead 3.
2
3. Remove the bolt 4 and ground lead 5
from the power tilt unit.
4. Remove the bolts 6, washers 7, collars
8, and shaft 9.
7-27
Bracket unit
S6AG7771
3
1
S6AG7770
5. Remove the E-clip 0, shaft A, and collar
7
B, and then remove the upper end of the
tilt rod from the swivel bracket.
6. Remove the power tilt unit C, and then
remove the collar D.
A
B
6
7
8

Removing the clamp bracket

1. Remove the ground lead terminal 1 and
self-locking nuts 2 of the through tube
3, and then remove the clamp brackets.
2
D
C
0
8
1
8
4
5
9
7
6
S6AG7780
7
S6AG7790
6AG3J11