SELVA MARINE Wahoo 15 Service Manual page 197

5
0
8
7
NOTE:
Tighten the screws 9, and then tighten the
screw 0.
Engine stop lanyard switch nut 5:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
Power tilt switch bracket screw 8:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
Power tilt switch screw 9 and 0:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
6. Connect the throttle cable ends to the
throttle pulley A.
A
B
4
6AG3J11
4
3
9
6
S6AG7A00
C
D
a
S6AG7480
Tiller handle (tiller handle model)
D
C
C
NOTE:
• When routing the engine stop lanyard
switch lead and power tilt switch lead
(power tilt model), make sure that it is not
pinched by the plate B and that there is no
slack in the lead in the area a shown.
• Make sure that the ends b of the outer
throttle cables C are fitted securely into the
grommet D as shown.
7. Install the tiller handle bracket to the
steering bracket, and then install the tiller
handle bracket cover and tighten the
bolts to the specified torque.
Tiller handle bracket cover bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
8. Connect the throttle cables to the throttle
cam.
NOTE:
• To adjust the throttle cables, see "Adjusting
the throttle cable (tiller handle model)" (3-
7).
• When adjusting the throttle cables, make
sure the ends b of the outer cables are not
pulled out of the grommet.
• Install the steering bracket cover after
adjusting the throttle cables.
9. Connect the engine stop lanyard switch
lead and power tilt switch lead (power tilt
model) and fasten the leads.
1
2
b
S6AG7470
3
4
5
6
7
8
9
7-4