SELVA MARINE Wahoo 15 Service Manual page 251

È Position the holder between the plastic ties.
É Fasten the wiring harness at the white tape with a plastic tie.
Ê Fasten the wiring harness, engine stop lanyard switch lead, and stator coil assembly lead with the holder.
Ë Install the terminals of the engine stop lanyard switch lead and wiring harness ground lead using the bolt,
and then apply Selva grease to the terminals and bolt.
Ì Fasten the lighting coil leads, wiring harness, and ground lead with the holder.
Í Install the terminal of the oil pressure switch lead so that the lead is routed as shown. Apply Selva
grease to the terminal and bolt, and then install the cap.
Î Insert the rubber plugs into the lighting coil connectors.
Ï Fasten the ignition coil lead with the holder.
Ñ Fasten the wiring harness with plastic ties.
Ò Install the plastic tie as shown and cut off the excess end of the tie to 3 mm (0.12 in) or less.
Ó Install the plastic ties as shown.
Ô Install the terminal of the ground lead using the bolt, making sure that the crimped section of the terminal
that secures the ground lead is facing outward as shown.
Õ The connectors can be fastened in any position in the holder.
6AG3J11
Electrical component and wiring harness routing
1
2
3
4
5
6
7
8
9
8-8