SELVA MARINE Wahoo 15 Service Manual page 253

F Positive battery lead connector (R)
G Starter relay connector (Br)
H Oil pressure switch connector (P)
I Rectifier Regulator connector (R)
J Lead (10-pin main harness coupler to starter relay) (Br) (remote control model) or neutral switch lead (Br)
(tiller handle model)
K Fuse lead (R)
L Rectifier Regulator lead (B)
M Oil pressure switch lead (P)
N Rectifier Regulator connector (R)
È Install the terminals of the negative battery cable and power tilt relay lead (B) using the bolt, making sure to
install the negative battery cable terminal under the power tilt relay lead (B) terminal, and then apply
Selva grease to the terminals and bolt.
É Fasten the wiring harness and leads in front of the starter motor with the holder.
Ê Install the terminals of the engine stop lanyard switch ground lead (tiller handle model), wiring harness
ground lead, and negative battery cable using the bolt, and then apply Selva grease to the terminals
and bolt.
Ë Fasten the lighting coil leads, wiring harness, fuse leads, and neutral switch lead (tiller handle model) with
the holder.
Ì Insert the rubber plug into the Rectifier Regulator connector (R).
Í Fasten the ignition coil lead and Rectifier Regulator lead with the holder.
Î Install the fuse bracket, making sure that the stopper on the bracket contacts the cylinder body.
Ï Install the terminals of the starter relay ground lead and Rectifier Regulator ground lead using the bolt, and
then apply Selva grease to the terminals and bolt.
Ñ Install the terminals of the positive battery cable and power tilt relay lead (R) using the bolt, apply Selva
grease to the terminals and bolt, and then cover the terminals with the cap.
Ò Install the terminals of the starter motor lead using the bolt and nut, apply Selva grease to the
terminals, bolt, and nut, and then cover the terminals with the caps.
Ó Install the starter motor lead terminal as shown.
Ô Route the starter relay lead (Br) and Rectifier Regulator ground lead between the starter relay and the
starter motor.
Õ Make sure that the power tilt relay lead (B) is not routed in front of the holder.
× Route the battery cables as shown and fasten them with the holder.
Ù Fasten the wiring harness at the white tape with the holder.
Ú Route the power tilt relay lead as shown.
Û Make sure that there is no slack in the battery cables.
Ü Install the terminal of the negative battery cable using the bolt, and then apply Selva grease to the
terminal and bolt.
Ý Install the terminal of the positive battery cable using the bolt and the terminals of the starter motor lead
using the bolt and nut, apply Selva grease to the terminals, bolts, and nut, and then cover the
terminals with the caps.
Þ Fold the lead (Y) (remote control model) back, and then fasten the connector and lead with the holder as
shown.
ß Install the bent terminal of the wiring harness to the starter motor.
À The connectors can be fastened in any position in the holder.
Á Fold the neutral switch lead (Br) back, and then connect it to the starter relay connector (Br). Fold the fuse
lead (R) back, and then connect it to the positive battery cable connector. Fasten the leads, which were
folded back, with the holder. (Tiller handle model)
Fold the lead (from 10-pin main harness coupler) (Br) back, and then connect it to the starter relay
connector (Br). Fold the fuse lead (R) back, and then connect it to the positive battery cable connector.
Fasten the leads, which were folded back, with the holder. (Remote control model)
6AG3J11
Electrical component and wiring harness routing
1
2
3
4
5
6
7
8
9
8-10