SELVA MARINE Wahoo 15 Service Manual page 183

F
N
R
3. Install the lower unit to the upper case,
and then tighten the lower case mounting
bolts 1 to the specified torque.
2
LT LT
572
NOTE:
• Before installing the lower unit to the upper
case, install the dowels 2 into the lower
case.
• Before installing the lower unit, make sure
that the locknut is removed from the shift
rod.
Lower case mounting bolt 1:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
4. Install the locknut 3, and then screw the
adjusting nut 4 onto the shift rod 5.
4
3
a
5
6AG3J11
F
N
R
S6AG6370
2
1104J
1
S6AG6410
S6AG6420
Drive shaft and lower case
NOTE:
The adjusting nut 4 must be screwed in a
minimum of 8.0 mm (0.31 in) a.
5. Tighten the locknut 3.
NOTE:
After connecting the shift rod, check that the
gear shift operates properly.
6. Install the anode 6, trim tab 7, and inlet
covers 8, and then tighten the bolts to
the specified torque.
8
8
NOTE:
Install the trim tab in its original position.
Anode bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
Trim tab bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
7
6
LT LT
572
LT LT
S6AG6430
572
6-18
1
2
3
4
5
6
7
8
9