Installing The Clamp Bracket; Installing The Power Tilt Unit - SELVA MARINE Wahoo 15 Service Manual

NOTE:
Be sure to remove the ground lead terminal
1 before removing the self-locking nuts 2.

Installing the clamp bracket

1. Apply grease to the threads of the self-
locking nut, and then tighten the nut 1
completely onto the shorter threaded end
of the through tube 2.
a
2
a b
2. Assemble the clamp brackets 3 and
swivel bracket 4, and then install the
through tube 2 from the port side.
3. Install the self-locking nut 5 onto the
through tube, and then tighten it to the
specified torque.
4. Install the ground lead terminals 6 to the
brackets using the bolts 7.
5. Install the stoppers 8, stopper nuts 9
and plugs 0.
6AG3J11
Clamp bracket and swivel bracket (power tilt model)
7
A A
1
b
A A
S6AG7800
5
3
9
8
0
7
6
Ó L-transom model
Ú S-transom model
NOTE:
Install the anode A with the projection facing
towards the bow.
Self-locking nut 5:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
Bolt 7: 8 N·m (0.8 kgf·m, 5.9 ft·lb)
Tilt stopper nut 9:
24 N·m (2.4 kgf·m, 17.7 ft·lb)

Installing the power tilt unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever.
WARNING
After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
4
Ó
0
9
Ú
0
9
2
8
9
3 0
A
S6AG7810
7
S6AG3220U
7-28
1
2
3
4
5
6
7
8
9