SELVA MARINE Wahoo 15 Service Manual page 162

POWR
7. Install the throttle cables onto the throttle
cam 9, and then adjust the throttle
cables. (Tiller handle model)
Install the cable joint onto the throttle
cam 9, and then adjust the throttle
cable. (Remote control model)
NOTE:
• To adjust the throttle cable(s), see "Adjust-
ing the throttle cable (tiller handle model)"
(3-7) or "Adjusting the throttle cable
(remote control model)" (3-8).
• Install the steering bracket cover after
adjusting the throttle cables. (Tiller handle
model)
8. Install the bracket E and warning indica-
tor assembly F.
E
9. Install the junction box bracket G. (Man-
ual tilt model)
Install the power tilt relay H. (Power tilt
model)
10. Connect the engine stop lanyard switch
lead (W) I. Install the engine stop lan-
yard switch lead (B) terminal K using the
bolt J. Connect the engine start button
leads (R) L and (Br) M. (Manual tilt
model/Tiller handle model)
Connect the power tilt motor leads N
and power tilt relay leads O, and then
install the terminal nuts P. Connect the
power tilt switch coupler Q and power tilt
switch lead (R) R. (Power tilt model)
5-63
Power unit
F
S6AG5H00
È
T
G
S
K
J
É
O N S
P
O NS
S
T
S H
È Manual tilt model/Tiller handle model
É Power tilt model
NOTE:
Install the power tilt motor leads N and
power tilt relay leads O to the terminals,
making sure to install the leads at an angle g
of approximately 15–20°.
I
L
M
S6AG5H10
S6AG5H11
g
Q
R
S6AG5H20
6AG3J11