Power Tilt Motor (Power Tilt Model); Disassembling The Power Tilt Motor - SELVA MARINE Wahoo 15 Service Manual

BRKT

Disassembling the power tilt motor

1. Remove the power tilt unit from the
bracket.
NOTE:
To remove the power tilt unit, see "Removing
the power tilt unit" (7-27).
2. Fully extend the tilt ram, and then open
the manual valve 1 by turning it counter-
clockwise.
WARNING
Make sure that the tilt ram is fully
extended before removing the power tilt
motor, otherwise fluid can spurt out from
the unit due to internal pressure.
NOTE:
To prevent the internal power tilt unit parts
from falling out, lay the power tilt unit on its
side so that the power tilt motor is in an
upright position before removing it.
3. Remove the bolts 2, and then remove
the power tilt motor assembly 3 and
gasket 4 from the tilt cylinder.
4. Remove the manual valve 5, O-ring 6,
and pin 7.
7-31
Bracket unit
7
2
5. Remove the stator 8 and O-ring 9 from
the power tilt motor base 0.
6. Remove the armature plate screw A,
and then remove the armature assembly
B.
A
3
6
5
4
7
8
9
B
2
S6AG7070
0
S6AG7145
S6AG7086
6AG3J11