SELVA MARINE Wahoo 15 Service Manual page 104

POWR
7. Remove the timing belt 5 from the
driven sprocket, and then remove it from
the drive sprocket.
5
CAUTION:
Unless directed to do so in the following
instructions, do
sprocket or driven sprocket when the tim-
ing belt is not installed. Otherwise the pis-
tons and valves will collide with each
other and be damaged.
8. Install a new timing belt 5 onto the drive
sprocket, and then install it onto the
driven sprocket with its part number in
the upright position e.
5
CAUTION:
• Do not twist, turn inside out, or bend the
timing belt beyond the maximum limit of
25 mm (1.0 in), otherwise it can be dam-
aged.
• Do not get oil or grease on the timing
belt.
NOTE:
Before installing the timing belt, make sure
that the marks on the drive sprocket and
driven sprocket are aligned with the marks on
the cylinder block and cylinder head.
5-5
Power unit
S6AG5101
not turn the drive
e
S6AG5110
9. Turn the drive sprocket clockwise 2
turns, and then check that the alignment
marks f and g are aligned.
g
5
10. Install the stator coil assembly 6 with
bolts 7.
11. Install the Woodruff key 8, and then
install the flywheel magnet 9.
m
n
n
E
9
k
NOTE:
• Be sure to remove any grease from the
tapered portion of the crankshaft h and fly-
wheel magnet k.
• Apply engine oil to the threads m of the fly-
wheel magnet nut 0 and washer n before
installation.
Stator coil assembly bolt 7:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
f
S6AG5100
0
9
7
6
h
8
S6AG5120
6AG3J11