SELVA MARINE Wahoo 15 Service Manual page 222

BRKT
2. Install the collar 1 onto the power tilt unit
2.
3. Install the power tilt unit 2, collars 3,
shaft 4, and washers 5 onto the clamp
bracket 6, and then tighten the bolts 7
to the specified torque.
4. Install the collars 8, upper end of the tilt
ram, shaft 9, and E-clip 0 to the swivel
bracket.
5. Install the ground lead terminal A to the
power tilt unit.
A
9
8
7
5
3
A
NOTE:
Install the ground lead A as shown.
Power tilt unit mounting shaft bolt 7:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Ground lead bolt B:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
6. Pass the power tilt motor lead C through
the hole a in the clamp bracket (STBD).
7. Fasten the power tilt motor lead C to the
clamp bracket with a plastic tie D.
7-29
Bracket unit
A
1
3
0
A
B
A
A
6
3
4
5
S6AG7820
C
b
NOTE:
Route the power tilt motor lead C to the front
of the stopper b.
8
8. Apply grease to all grease nipples until it
comes out from the areas c.
2
A A
7
D
c
c
A A
a
S6AG7830
S6AG7840
6AG3J11