SELVA MARINE Wahoo 15 Service Manual page 247

B Charge coil connector (G/R)
C Engine stop lanyard switch connector (tiller handle model) (W)
D Engine start button connector (tiller handle model with electric starter) (Br)
E Engine start button connector (tiller handle model with electric starter) (R)
F Prime Start connectors (L)
G Tachometer connector (G)
H Connector (10-pin main harness coupler to CDI unit) (remote control model) (W)
I Connector (10-pin main harness coupler to CDI unit) (remote control model) (P)
J Connector (10-pin main harness coupler to fuse) (remote control model) (R)
K Connector (10-pin main harness coupler to CDI unit) (remote control model) (G)
L Lead (10-pin main harness coupler to CDI unit) (remote control model) (P)
M Lead (10-pin main harness coupler to CDI unit) (remote control model) (W)
N Lead (10-pin main harness coupler to CDI unit) (remote control model) (G)
È Pass the engine stop lanyard switch lead (tiller handle model), neutral switch lead (tiller handle model with
electric starter), and Prime Start lead through the grommet.
É Pass the pulser coil lead through the grommet.
Ê Be sure not to pinch the wiring harness and leads with the holder cover.
Ë Fasten the stator coil assembly lead, wiring harness, fuse lead (electric starter model), neutral switch lead,
engine start button lead (tiller handle model with electric starter), and engine stop lanyard switch lead (tiller
handle model) with the holder.
Ì Cover the edge of the coupler with the protective tube so that it does not contact the leads.
Í Install the holder as shown.
Î The connectors can be fastened in any position in the holder. However, do not fasten the pulser coil
connector (W/R) and engine stop lanyard switch connector (W) in lowest opening in the holder.
Ï Fold the charge coil lead (B/R, G/R) back, connect it to the lead connectors (B/R, G/R), and then fasten it
with the holder.
Ñ Fold the fuse lead (R) back, and then connect it to the engine start button connector (R).
Ò Fasten the engine stop lanyard switch lead (B) and neutral switch lead (Br) (tiller handle model with electric
starter) with the holder.
6AG3J11
Electrical component and wiring harness routing
1
2
3
4
5
6
7
8
9
8-4