Adjusting The Throttle Cable (Remote Control Model) - SELVA MARINE Wahoo 15 Service Manual

6. Turn the throttle grip to the fully open and
fully closed positions and check that the
fully open stopper a and fully closed
stopper b on the throttle cam contact
throttle cam bracket as shown. Repeat
steps 2–5 if necessary.
È
a
É
b
È Fully open position
É Fully closed position
7. Connect the throttle link rod 1 to the free
accel lever.
NOTE:
After adjusting the throttle cables, adjust the
throttle link. (Tiller handle model)
After adjusting the throttle cable, adjust the
throttle link. (Remote control model)
Adjusting the throttle cable (remote
control model)
1. Disconnect the throttle link rod 1 from
the free accel lever.
2. Loosen the locknut 2, remove the clip
3, and then disconnect the throttle cable
joint 4.
6AG3J11
5
1
a
6
3. Set the remote control lever to the neu-
tral position.
4. Check that the fully closed stopper a on
the cam contacts the throttle cam bracket
5.
5. Adjust the position of the throttle cable
joint 4 until its hole is aligned with the
set pin on the throttle cam 6.
S6AG3340
WARNING
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) b.
NOTE:
Pull the throttle cable 7 towards the engine
3
to remove any free play in the cable before
adjusting the position of the throttle cable
joint.
6. Connect the throttle cable joint 4, install
the clip 3, and then tighten the locknut
2.
Power unit / Control system
3
7
2
4
b
1
2
S6AG3360
3
4
5
6
S6AG1090
7
8
9
3-8