Assembling The Tilt Cylinder - SELVA MARINE Wahoo 15 Service Manual

3. Check the tilt cylinder end screw 6, dust
seal 7, and backup ring 8. Replace if
cracked or scratched.
4. Check the tilt ram 9. Polish with 400–
600-grit sandpaper if there is light rust or
replace if bent or excessively corroded.
9
7
6
1
8
2
4
5. Check the tilt piston absorber valves 0.
Clean if there is dirt or residue.

Assembling the tilt cylinder

CAUTION:
• Do not use a rag when assembling the
power tilt unit as dust and particles on
the power tilt unit components can lead
to poor performance.
• Do not reuse the O-ring, always replace
it with a new one.
6AG3J11
3
5
S6AG7270
0
S6AG7280
7
Power tilt cylinder (power tilt model)
NOTE:
Lubricate the parts with ATF Dexron II during
assembly.
1. Install a new dust seal 1, new O-rings 2
and 3, and the backup ring 4 into the tilt
cylinder end screw 5.
1
A A
5
2
4
3
2. Install the tilt cylinder end screw 5 and
tilt piston 6 to the tilt ram 7.
3. Hold the tilt piston in a vise using alumi-
num plates on both sides.
4. Tighten the tilt ram 7 to the specified
torque.
7
5
6
Power tilt wrench 8: 90890-06560
Tilt ram 7:
45 N·m (4.5 kgf·m, 33.2 ft·lb)
1
4
2
3
5
S6AG7300
8
S6AG7245
7-44
1
2
3
4
5
6
7
8
9