Bleeding The Power Tilt Unit - SELVA MARINE Wahoo 15 Service Manual

14. Tighten the tilt cylinder end screw to the
specified torque.
Power tilt wrench 8: 90890-06560
Tilt cylinder end screw 5:
60 N·m (6.0 kgf·m, 44.3 ft·lb)

Bleeding the power tilt unit

NOTE:
Make sure that the tilt ram is fully extended.
1. Place the power tilt unit in an upright
position.
2. Turn the manual valve 1 clockwise 90°
to close it.
3. Remove the reservoir cap 2, and then
check the fluid level in the reservoir.
6AG3J11
8
S6AG7225
7
Power tilt cylinder (power tilt model)
NOTE:
• If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole.
• If fluid is below the correct level, add the
recommended fluid.
Recommended power tilt fluid:
ATF Dexron II
4. Install the reservoir cap 2, and then
tighten it to the specified torque.
Reservoir cap 2:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
1
2
3
4
5
6
7
8
9
7-46