Typical Networking Of The S5600 Controller Subrack (Fc And Iscsi Host Ports) - Huawei OceanStor S5600 Initial Configuration Manual

2 Setting Up the Management Environment
In Figure
l
l
l
l
l
l
l
l
This networking avoids single point failures of FC HBAs, Fabrics and controllers.
2.2.3 Typical Networking of the S5600 Controller Subrack (FC and
iSCSI Host Ports)
Introduce the typical networking of the S5600 controller subrack (FC and iSCSI host ports).
AS with Two FC HBAs+Two NICs+Two Fabrics+ Two Subnets
Figure 2-3
subnets.
2-8
2-2, ports are allocated into zones as follows.
zone1: port1 and port5
zone2: port1 and port7
zone3: port2 and port6
zone4: port2 and port8
zone5: port3 and port9
zone6: port3 and port11
zone7: port4 and port10
zone8: port4 and port12
NOTE
For the iSCSI networking:
In this document, the service segment IP addresses on the storage device side are configured to
l
192.168.0.0/19.
The two iSCSI host ports on each controller of the S5600 controller subrack (FC and iSCSI host
l
ports) are independent of each other.
The networking realizes the one-subnet model. A Ethernet switch can form a subnet. Two or more
l
Ethernet switches can also be cascaded to form a subnet.
Dividing the ports on the Ethernet switches to virtual LANs (VLANs) can improve the performance
l
of the system.
shows the networking of AS with two FC HBAs+two NICs+two Fabrics+ two
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OceanStor S5600 Storage System
Initial Configuration Guide
Issue 02 (2009-09-30)