Huawei OceanStor S5600 Initial Configuration Manual page 58

3 Configuring the Storage System
Figure 3-2
host ports.
Figure 3-2 Iinitial configuration flow chart of the S5600 configured with FC and iSCSI host
ports
Create a
RAID group
Create a
3-4
NOTE
host displayed on the OSM3.0 main interface is a virtual one created for easy management.
You must add a port to a virtual host so that the virtual host can match a physical AS.
To match each AS with one virtual host, you must add the information about the physical ports of the
l
ASs to the virtual hosts.
The storage device identifies each AS through the information about the physical port of the AS.
l
shows the initial configuration flow chart of the S5600 configured with FC and iSCSI
Log in to
the OSM3.0
Create a
host group
Add a host
LUN
Add a
mapping
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Start
Set the FC Set the iSCSI
host ports of host ports of the
the controllers controllers
Add a port
1
Start the
CHAP
authentication
End
OceanStor S5600 Storage System
Initial Configuration Guide
Log in to the AS
Set up the
connection from the
AS to the controller
2
Using CHAP
authentication on
an AS
Use a LUN
on an AS
Issue 02 (2009-09-30)