Figure 3-29 Selecting Linux-Iscsi - Huawei OceanStor S5600 Initial Configuration Manual

OceanStor S5600 Storage System
Initial Configuration Guide

Figure 3-29 Selecting linux-iscsi

5.
Step 4 Enter the command chkconfig iscsi on to start iSCSI services.
Step 5 Enter the command vi /etc/initiatorname.iscsi. Edit the file initiatorname.iscsi to name the
initiator of the iSCSI port. The following information is displayed:
## DO NOT EDIT OR REMOVE THIS FILE!
## If you remove this file, the iSCSI daemon will not start.
## If you change the InitiatorName, existing access control lists
## may reject this initiator.
## for each iSCSI initiator.
InitiatorName=iqn.1987-05.com.cisco:01.ea91e29559f
~
~
~
~
-- INSERT --
7,21
Step 6 Press ESC to exit from the file editing mode.
Step 7 Enter the command :wq to save the settings and exit from the file editing interface.
Step 8 Enter the command vi /etc/iscsi.conf, add the iSCSI IP address (that is, the destination IP) set
at the controller subrack side. The following information is displayed:
DiscoveryAddress=192.168.1.18
Issue 02 (2009-09-30)
You can correctly install the rpm package as prompted by the system.
All
NOTE
Enter the initiator name of the iSCSI port behind InitiatorName=.
l
The initiator name contains numbers, letters, full stops, hyphens, and colons. The first character cannot
l
be a hyphen. Do not use invalid characters to name the initiator node. Otherwise, the AS fails to connect
storage devices.
For multiple ASs connected to a controller, the initiators must be named differently.
l
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
The InitiatorName must be unique
Do NOT duplicate iSCSI InitiatorNames.
3 Configuring the Storage System
3-37