Configuring The Ip Address Of The Management Network Port On The Controller; Figure 1-10 Interface Of Successful Login; Table 1-3 Syntax And Parameters Of The Command - Huawei OceanStor S5600 Initial Configuration Manual

OceanStor S5600 Storage System
Initial Configuration Guide

Figure 1-10 Interface of successful login

Step 5 The user successfully logs in and enters the CLI mode.
----End
1.6.3 Configuring the IP Address of the Management Network Port
on the Controller
Introduce how to configure the IP address of the management network port on the controller.
Context
In CLI mode, run the chgctrlip command to set the IP addresses of the management network
ports on the controllers.
command.

Table 1-3 Syntax and parameters of the command

Syntax
chgctrlip -c controller ID { -a IP
address | -s subnet mask | -g gateway } *
a: controller A.
b: controller B.
Issue 02 (2009-09-30)
Table 1-3 describes the syntax and parameters of the chgctrlip
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Process of the Initial Configuration
Description
-c controller ID: controller ID. The value is
l
a b
a or b .
-a IP address: the IP address of the
l
management network port on the controller.
-s subnet mask: the subnet mask.
l
-g gateway: the gateway.
l
1-17