Planning The Networking; Figure 1-1 Steps Of The S5600 Initial Configuration - Huawei OceanStor S5600 Initial Configuration Manual

OceanStor S5600 Storage System
Initial Configuration Guide

Figure 1-1 Steps of the S5600 initial configuration

Configure NICs or FC HBAs on the ASs
Set the IP addresses of the management

1.2 Planning the Networking

Introduce the typical networking of S5600.
The S5600 is a storage system on the storage area network (SAN).
The front-end host ports of S5600 controller subracks are described as follows:
Issue 02 (2009-09-30)
Start
Plan the networking
Install and check the hardware
Set up the management environment
network port on the controllers
Log in to the OSM3.0
Configure the storage system
Set additional information
End
NOTE
The S5600 storage device can be used for setting up the two-node system cluster environment. The
description of installing and configuring the cluster is included in the
Hardware" section. For details on how to set up the cluster environment, see the related documents.
The two-node system cluster described in this document is a high-availability cluster. In the cluster, one
node, as the primary node, provides services; the other node, as the secondary node, runs idly or runs some
non-core applications.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Process of the Initial Configuration
"1.3 Installing and Checking the
1-3