Figure 4-9 Short Message - Huawei OceanStor S5600 Initial Configuration Manual

OceanStor S5600 Storage System
Initial Configuration Guide
Prerequisite
Before using the function of alarm by short messages, make sure that the GSM modem is properly
installed. To install the GSM modem, do as follows:
1.
2.
3.
The sending channel of controller A and that of controller B must not be opened in the same
period.
When the system works with single controller:
l
l
Procedure
Step 1 On the OSM3.0 main interface, click Alarm. The Current Fault interface is displayed. In the
Alarm navigation tree, click Configuration Operation. The Alarm Email interface is
displayed. Click the Short Message tab. The Short Message interface is displayed. See
4-9.

Figure 4-9 Short Message

Issue 02 (2009-09-30)
Insert the SIM card into the GSM modem.
Insert the GSM modem into the serial port of the storage device.
Connect the GSM modem to the power. If the red indicator of the GSM modem blinks, it
indicates that the installation is successful.
CAUTION
If the sending channel status is Open, you can set it to Close. After that, you cannot set the
status to Open again.
If the status of the sending channel is Close, you cannot set it to Open.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Setting Additional Information
Figure
4-11