Figure 3-3 Creating A Raid 0 Group; Table 3-1 Parameters For Creating A Raid 0 Group - Huawei OceanStor S5600 Initial Configuration Manual

3 Configuring the Storage System

Figure 3-3 Creating a RAID 0 group

Step 3 Enter the parameters for creating a RAID 0 group.

Table 3-1 Parameters for creating a RAID 0 group

Parameter
Name
Level
Hard Disk
Type
a: The coffer disks of the S5600 controller subrack are the FC disks. In the S5600, the FC
hard disks, the serial advanced technology attachment (SATA) hard disks and the SSD hard
disks can be inserted interchangeably in the same subrack or between different subracks, but
it is recommended that use hard disk of the same type for the same subrack. In addition, the
RAID group cannot be built on hard disks of different types.
Step 4 Select free disks from the storage system as the member disks of a RAID 0 group.
To create a RAID 0 group, the number of the selected hard disks must be larger than 1 and
smaller than 25.
Step 5 Click OK. The Confirm dialog box is displayed.
3-8
Description
This parameter indicates the name of the RAID group. Note the following
when you set the parameter.
The name must be unique.
l
The name can contain letters, numbers, underscores (_) , and hyphens
l
(-), and the first character cannot be a hyphen.
The name contains 1 to 32 characters.
l
Select RAID 0.
FC, SATA or SSD.
a
After you select a disk type, the information about the free disks of this
type is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OceanStor S5600 Storage System
Initial Configuration Guide
Table 3-1 describes the parameters.
Issue 02 (2009-09-30)