Ils File Setup Window - Christie CP2210 User Manual

Control
Auto
LampLOC™ Progress Bar
Cancel Auto

6.14.4 ILS File Setup Window

WARNING
(MALM) colliding, move the MALM to the out position before calibrating the lens or resetting
the MALM. When performing a lens calibration keep your fingers away from moving parts.
Use the ILS File Setup window to modify the Intelligent Lens System (ILS) settings in an ILS file. Tap Menu
> Advanced Setup > ILS File Setup
The ILS File Setup window is not available if you have not selected the ILS Installed option in the Lens Setup
window. Changes made to settings are applied to all channels that use the ILS file. Tap once to increase or
decrease the focus, offset, or zoom by a single increment. Press and hold a button to increase or decrease the
focus, offset, or zoom by multiple increments. If you adjust the focus, offset, or zoom of the lens mount
manually, the new settings are not saved in the ILS file
Table 6.16 ILS File Setup A
Control
Focus
Zoom
Offset
Quick Reset
MALM Reset
CP2210 User Manual
020-100410-08 Rev. 1 (05-2014)
Description
Shows the current LampLOC
Cancels the LampLOC calibration.
To prevent the projection lens and the Motorized Auxiliary Lens Mount
Figure 6-22 ILS File Setup Window
Description
Adjusts the focus.
Adjusts the zoom.
Adjusts the offset.
Resets the lens to the mechanical center before moving back to the original position.
Resets the position of the MALM to the mechanical reference point.
™
procedure completion status.
.
Section 6: Projector Menus
6-29