Using The Console Cli - D-Link DES-1228 Reference Manual

The DES-1228/ME support a console management interface that allows the user to connect to the Switch's management agent via
a serial port and a terminal or a computer running a terminal emulation program. The console can also be used over the network
using the TCP/IP Telnet protocol. The console program can be used to configure the Switch to use an SNMP-based network
management software over the network.
This chapter describes how to use the console interface to access the Switch, change its settings, and monitor its operation.
Note: Switch configuration settings are saved to non-volatile RAM using the save command. The current
configuration will then be retained in the Switch's NV-RAM, and reloaded when the Switch is rebooted. If the
Switch is rebooted without using the save command, the last configuration saved to NV-RAM will be loaded.
Connecting to the Switch
The console interface is used by connecting the Switch to a VT100-compatible terminal or a computer running an ordinary
terminal emulator program (e.g., the HyperTerminal program included with the Windows operating system) using an RS-232C
serial cable. Your terminal parameters will need to be set to:
•
VT-100 compatible
•
9600 baud
•
8 data bits
•
No parity
•
One stop bit
•
No flow control
Users can also access the same functions over a Telnet interface. Once users have set an IP address for your Switch, users can use
a Telnet program (in VT-100 compatible terminal mode) to access and control the Switch. All of the screens are identical, whether
accessed from the console port or from a Telnet interface.
After the Switch reboots and users have logged in, the console looks like this:
DES-1228/ME Metro Ethernet Switch Command Line Interface
Copyright(C) 2009 D-Link Corporation. All rights reserved.
username:
Commands are entered at the command prompt, DES-1228/ME:4#.
There are a number of helpful features included in the CLI. Entering the ? command will display a list of all of the top-level
commands.
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Firmware: Build 1.00.B04
Figure 2-1. Initial Console Screen after logging in
U
SING THE
3
2
C CLI
ONSOLE