Vlan Commands - D-Link DES-1228 Reference Manual

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create vlan
delete vlan
create vlan vlanid
delete vlan vlanid
config vlan vlanid
config vlan
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
Each command is listed, in detail, in the following sections.
create vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a VLAN v1, tag 2:
DES-1228/ME:4#create vlan v1 tag 2
Command: create vlan v1 tag 2
Success.
DES-1228/ME:4#
delete vlan
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
<vlan_name 32> {tag <vlanid 2-4094> | advertisement}
<vlan_name 32>
<vidlist> {advertisement}
<vidlist>
<vidlist> {[ add [ tagged | untagged | forbidden ] |delete ] <portlist> | advertisement [ enable
| disable ] | name <vlan_name 32>}(1)
<vlan_name 32> {[ add [ tagged | untagged | forbidden ] |delete ] <portlist> | advertisement
[ enable | disable ]}(1)
[<portlist> | all] {state [enable | disable]|ingress_checking [enable | disable] |
acceptable_frame [tagged_only | admit_all]|pvid <vlanid 1-4094>}(1)
{[<vlan_name 32> | vlanid <vidlist> | ports <portlist>]}
<portlist>
Used to create a VLAN on the Switch.
create vlan <vlan_name 32> {tag <vlanid 2-4094> | advertisement}
This command allows the user to create a VLAN on the Switch.
<vlan_name 32> − The name of the VLAN to be created.
<vlanid 2-4094> − The VLAN ID of the VLAN to be created. Allowed values = 2-4094
advertisement − Specifies that the VLAN is able to join GVRP. If this parameter is not
set, the VLAN cannot be configured to have forbidden ports.
Each VLAN name can be up to 32 characters. Up to 4094 static VLANs may be created
per configuration. Only Administrator-level users can issue this command.
119
16
VLAN C
OMMANDS