D-Link DES-1228 Reference Manual page 22

enable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable HTTP and configure port number:
DES-1228/ME:4#enable web 80
Command: enable web 80
Success.
DES-1228/ME:4#
disable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable HTTP:
DES-1228/ME:4#disable web
Command: disable web
Success.
DES-1228/ME:4#
save
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to enable the HTTP-based management software on the Switch.
enable web <tcp_port_number 1-65535>
This command is used to enable the Web-based management software on the Switch.
<tcp_port_number 1-65535> − The TCP port number. TCP ports are numbered between 1
and 65535. The "well-known" port for the Web-based management software is 80.
Only Administrator-level users can issue this command.
Used to disable the HTTP-based management software on the Switch.
disable web
This command disables the Web-based management software on the Switch.
None.
Only Administrator-level users can issue this command.
Used to save changes in the Switch's configuration to non-volatile RAM.
save {[config {config_id <value 1-2>} | log | all]}
This command is used to enter the current switch configuration into non-volatile RAM. The
saved switch configuration will be loaded into the Switch's memory each time the Switch is
restarted.
config – Used to save the current configuration to a file.
log – Used to save the current log to a file. The log file cannot be deleted.
all – Save changes to currently activated configurations and save log. If no keywords are
specified, save the changes to the configuration. If there are no keywords specified, the
changes will be saved to the configuration.
Only Administrator-level users can issue this command.
17