D-Link DES-1228 Reference Manual page 219

config authen server_host
Parameters
Restrictions
Example usage:
To configure a TACACS+ authentication server host, with port number 4321, a timeout value of 12 seconds and a
retransmit count of 4.
DES-1228/ME:4#config authen server_host 10.1.1.121 protocol tacacs+ port 4321 timeout
12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol tacacs+ port 4321 timeout 12
retransmit 4
Success.
DES-1228/ME:4#
delete authen server_host
Purpose
Syntax
Description
Parameters
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
attempts to access the Switch with the authentication protocol enabled, the Switch will
send authentication packets to a remote TACACS/XTACACS/TACACS+/RADIUS server
host on a remote host. The TACACS/XTACACS/TACACS+/RADIUS server host will then
verify or deny the request and return the appropriate message to the Switch. More than
one authentication protocol can be run on the same physical server host but, remember
that TACACS/XTACACS/TACACS+/RADIUS are separate entities and are not compatible
with each other. The maximum supported number of server hosts is 16.
server_host <ipaddr> − The IP address of the remote server host the user wishes to alter.
protocol – The protocol used by the server host. The user may choose one of the
following:

tacacs – Enter this parameter if the server host utilizes the TACACS protocol.
xtacacs − Enter this parameter if the server host utilizes the XTACACS protocol.

tacacs+ − Enter this parameter if the server host utilizes the TACACS+ protocol.

radius − Enter this parameter if the server host utilizes the RADIUS protocol.

port <int 1-65535> − Enter a number between 1 and 65535 to define the virtual port
number of the authentication protocol on a server host. The default port number is 49 for
TACACS/XTACACS/TACACS+ servers and 1812 and 1813 for RADIUS servers but the
user may set a unique port number for higher security.
key <key_string 254> − Authentication key to be shared with a configured TACACS+ or
RADIUS server only. Specify an alphanumeric string up to 254 characters or choose
none.
timeout <int 1-255> − Enter the time in seconds the Switch will wait for the server host to
reply to an authentication request. The default value is 5 seconds.
retransmit <int 1-255> − Enter the value in the retransmit field to change how many times
the device will resend an authentication request when the server does not respond. This
field is inoperable for the TACACS+ protocol.
Only Administrator-level users can issue this command.
Used to delete a user-defined authentication server host.
delete authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
This command is used to delete a user-defined authentication server host previously
created on the Switch.
server_host <ipaddr> − The IP address of the remote server host to be deleted.
protocol – The protocol used by the server host the user wishes to delete. The user may
choose one of the following:

tacacs – Enter this parameter if the server host utilizes the TACACS protocol.
xtacacs − Enter this parameter if the server host utilizes the XTACACS protocol.

214