D-Link DES-1228 Reference Manual page 27

config greeting _message
Restrictions
Example usage:
To modify the banner to read "Say goodnight, Gracie":
DES-1228/ME:4# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
Copyright(C) 2009 D-Link Corporation. All rights reserved.
================================================================================
<Function Key>
Ctrl+C Quit without save
Ctrl+W Save and quit
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------
show greeting_message
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
described on the Banner Editor:
Quit without save:
Save and quit:
Move cursor:
Delete line:
Erase all setting:
Reload original setting:
Only Administrator-level users can issue this command. Other restrictions include:
If the "reset/reset config" command is executed, the modified banner will remain
modified. However, the "reset system" command will reset the modified banner to the
original factory banner.
The capacity of the banner is 6*80. 6 Lines and 80 characters per line.
Ctrl+W will only save the modified banner in the DRAM. Users need to type the "save"
command to save it into FLASH.
Only valid in threshold level.
DES-1228/ME Metro Ethernet Switch
Command Line Interface
Firmware: Build 1.00.B04
Used to view the currently configured greeting message configured on the Switch.
show greeting_message
This command is used to view the currently configured greeting message on the
Switch.
None.
None.
Ctrl+C
Ctrl+W
Left/Right/Up/Down
Ctrl+D
Ctrl+X
Ctrl+L
<Control Key>
left/right/
up/down Move cursor
22