D-Link DES-1228 Reference Manual page 286

config loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the loopdetect state to enable:
DES-1228/ME:4#config loopdetect ports 1-5 state enable
Command: config loopdetect ports 1-5 state enable
Success
DES-1228/ME:4#
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable loop-back detection on the switch:
DES-1228/ME:4#enable loopdetect
Command: enable loopdetect
Success
DES-1228/ME:4#
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable loop-back detection on the switch:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to configure loopback detection on the switch.
config loopdetect ports [<portlist> | all] | state [enable | disable]
Used to configure loopback detection on the switch.
<portlist> − Specifies a range of ports for the loopback detection
state [enable | disable] – Allows the loopback detection to be disabled or enabled.
Only Administrator-level users can issue this command.
Used to globally enable loopback detection on the switch.
enable loopdetect
Used to globally enable loopback detection on the switch.
None.
Only Administrator-level users can issue this command.
Used to globally disable loopback detection on the switch.
disable loopdetect
Used to globally disable loopback detection on the switch.
None.
Only Administrator-level users can issue this command.
281