D-Link DES-1228 Reference Manual page 163

Example usage:
To configure 802.1X authentication parameters for ports 1 – 20:
DES-1228/ME:4#config 802.1x auth_parameter ports 1–20 direction both
Command: config 802.1x auth_parameter ports 1–20 direction both
Success.
DES-1228/ME:4#
config 802.1x auth_protocol
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DES-1228/ME:4# config 802.1x auth_protocol radius_eap
Command: config 802.1x auth_protocol radius_eap
Success.
DES-1228/ME:4#
config 802.1x init
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To initialize the authentication state machine of all ports:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to configure the 802.1X authentication protocol on the Switch.
config 802.1x auth_protocol [local | radius_eap]
The config 802.1x auth_protocol command enables users to configure the
authentication protocol.
radius_eap | local – Specify the type of authentication protocol desired.
Only Administrator-level users can issue this command.
Used to initialize the 802.1X function on a range of ports.
config 802.1x init {port_based ports [<auth_portlist> | all] | mac_based | ports
[<portlist> | all] {mac_address <macaddr>}]
The config 802.1x init command is used to immediately initialize the 802.1X functions on
a specified range of ports or for specified MAC addresses operating from a specified range
of ports.
port_based – This instructs the Switch to initialize 802.1X functions based only on the port
number. Ports approved for initialization can then be specified.
mac_based − This instructs the Switch to initialize 802.1X functions based only on the
port number or the MAC address. MAC addresses approved for initialization can then be
specified.
ports <auth_portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> − Enter the MAC address to be initialized.
Only Administrator-level users can issue this command.
158