Igmp Snooping Commands - D-Link DES-1228 Reference Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config igmp_snooping
config igmp_snooping querier
config router_ports
config router_port_forbidden
enable igmp snooping
show igmp snooping
disable igmp snooping
show router ports
show igmp_snooping forwarding
show igmp_snooping group
config igmp snooping
data_driven_learning
config igmp_snooping
data_driven_learning
max_learned_entry
clear igmp snooping data_
driven _group
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[ vlan_name <vlan_name 32> |all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-16711450> | state
[enable|disable] | fast_leave [enable|disable]}(1)
[ vlan_name <vlan_name 32> |all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-255>
|last_member_query_interval <sec 1-25> | state [enable|disable] }(1)
<vlan_name 32> [add | delete] <portlist>
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32> }
{forward_mcrouter_only}
{vlan <vlan_name 32>} {[static | dynamic | forbidden]}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>} {data_driven}
[ vlan_name <vlan_name 32> |all] {aged_out [enable|disable]}(1)
<value 1-64>
[ vlan_name <vlan_name 32> | all ]
Used to configure IGMP snooping on the Switch.
config igmp_snooping [ vlan_name <vlan_name 32> |all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> |leave_timer <sec 1-16711450> | state
[enable|disable] | fast_leave [enable|disable]}(1)
This command allows the user to configure IGMP snooping on the Switch.
<vlan_name 32> − The name of the VLAN for which IGMP snooping is to be configured.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a host can be a
member of a multicast group without the Switch receiving a host membership report. The
default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a route can be
a member of a multicast group without the Switch receiving a host membership report. The
default is 260 seconds.
leave_timer <sec 0-16711450> − Specifies the maximum amount of time in seconds
between the Switch receiving a leave group message from a host, and the Switch issuing
a group membership query. If no response to the membership query is received before the
Leave Timer expires, the (multicast) forwarding entry for that host is deleted. The default
setting is 2.
IGMP S
NOOPING
134
19
C
OMMANDS