D-Link DES-1228 Reference Manual page 161

config 802.1x auth_mode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1X authentication by MAC address:
DES-1228/ME:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-1228/ME:4#
config 802.1x capability ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1X capability on ports 1-10:
DES-1228/ME:4#config 802.1x capability ports 1–10 authenticator
Command: config 802.1x capability ports 1–10 authenticator
Success.
DES-1228/ME:4#
config 802.1x auth_parameter
Purpose
Syntax
Description
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to configure the 802.1X authentication mode on the Switch.
config 802.1x auth_mode {port_based | mac_based]
The config 802.1x auth_mode command is used to enable either the port-based or Host-
based 802.1X authentication feature on the Switch.
[port_based | mac_based] − The Switch allows users to authenticate 802.1X by either port
or MAC address.
Only Administrator-level users can issue this command.
Used to configure the 802.1X capability of a range of ports on the Switch.
config 802.1x capability ports [<portlist> | all] [authenticator | none]
The config 802.1x command has two capabilities that can be set for each port,
authenticator and none.
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
authenticator − A user must pass the authentication process to gain access to the network.
none − The port is not controlled by the 802.1X functions.
Only Administrator-level users can issue this command.
Used to configure the 802.1X Authentication parameters on a range of ports. The default
parameter will return all ports in the specified range to their default 802.1X settings.
config 802.1x auth_parameter ports [ <portlist> |all] [default | {direction [both|in] |
port_control [force_unauth|auto|force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-
65535> | max_req <value 1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable|disable]}(1)]
The config 802.1x auth_parameter command is used to configure the 802.1X
Authentication parameters on a range of ports. The default parameter will return all ports
156