D-Link DES-1228 Reference Manual page 78

Example usage:
To configure a Syslog host:
DES-1228/ME:4#config syslog host 1 severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-1228/ME:4#
Example usage:
To configure a Syslog host for all hosts:
DES-1228/ME:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-1228/ME:4#
delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
DES-1228/ME:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-1228/ME:4#
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to remove a syslog host that has been previously configured, from the Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog host that has been previously
configured from the Switch.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Only Administrator-level users can issue this command.
Used to display the syslog hosts currently configured on the Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog hosts that are currently
configured on the Switch.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are
four available indexes, numbered 1 through 4.
None.
73