D-Link DES-1228 Reference Manual page 105

Example usage:
To display traffic control setting for ports 1-4:
DES-1228/ME:4#show traffic control 1-4
Command: show traffic control 1-4
Traffic Storm Control Trap :[None]
Port Thres Broadcast Multicast Unicast
hold Storm
---- ----- --------- --------- -------- -------- ----- --------
1 64 Disabled
2 64 Disabled
3 64 Disabled
4 64 Disabled
Total Entries : 4
DES-1228/ME:4#
config traffic trap
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure notifications to be sent when a packet storm control has been detected and cleared by the Switch.
DES-1228/ME:4# config traffic trap both
Command: config traffic trap both
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Storm Storm
Disabled Disabled drop
Disabled Disabled drop
Disabled Disabled drop
Disabled Disabled drop
Used to configure the trap settings for the packet storm control mechanism.
config traffic trap [none | storm_occurred | storm_cleared | both]
This command will configure how packet storm control trap messages will be used when a
packet storm is detected by the Switch. This function can only be used for the software
traffic storm control mechanism (when the action field in the config traffic control
command is set as shutdown).
none – No notification will be generated or sent when a packet storm control is detected by
the Switch.
storm _occurred – A notification will be generated and sent when a packet storm has been
detected by the Switch.
storm_cleared − A notification will be generated and sent when a packet storm has been
cleared by the Switch.
both − A notification will be generated and sent when a packet storm has been detected
and cleared by the Switch.
Only Administrator-level users can issue this command.
Action Count Time
down Interval
0 5
0 5
0 5
0 5
100