D-Link DES-1228 Reference Manual page 279

DES-1228/ME:4#create address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-
00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-00-04
Success.
DES-1228/ME:4#
config address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure address binding on the Switch:
DES-1228/ME:4#config address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-
00-05
Command: config address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-00-05
Success.
DES-1228/ME:4#
config address_binding ip_mac ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure address binding on the Switch:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to configure an IP-MAC Binding entry.
config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports
[<portlist> | all]}
This command will configure an IP-MAC Binding entry.
<ipaddr> – The IP address of the device where the IP-MAC binding is made.
<macaddr> – The MAC address of the device where the IP-MAC binding is made.
<portlist> – Specifies a port or range of ports to be configured for address binding.
all – Specifies that all ports on the switch will be configured for address binding.
Only Administrator-level users can issue this command.
Used to configure an IP-MAC state to enable or disable for specified ports.
config address_binding ip_mac ports [<portlist> | all] state [enable | disable]
allow_zeroip [enable | disable]
This command will configure IP-MAC state to enable or disable for specified ports.
<portlist> − Specifies a port or range of ports.
all – specifies all ports on the switch.
state [enable | disable] – Enables or disables the specified range of ports.
Only Administrator-level users can issue this command.
274