Layer 3 Control Packet Filtering - D-Link DES-1228 Reference Manual

The Layer 3 Control Packet Filtering commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config cpu_filter l3_control_pkt
show cpu_filter l3_control_pkt
Each command is listed, in detail, in the following sections.
config cpu_filter l3_control_pkt
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Layer 3 Control Filter setup of the Switch per port:
DES-1228/ME:4#config cpu_filter l3_control_pkt 1 ospf state enable
Command: config cpu_filter l3_control_pkt 1 ospf state enable
Success.
DES-1228/ME:4#
show cpu_filter l3_control_pkt
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the Layer 3 Control Filter setup of the Switch per port:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
L
AYER
Parameters
<portlist> [{dvmrp|pim|igmp_query|ospf|rip|vrrp}(1) | all] state [enable|disable]
{<portlist>}
This command is used to configure the Layer 3 Control Filter setup of the Switch per port.
config cpu_filter l3_control_pkt <portlist> [{dvmrp|pim|igmp_query|ospf|rip|vrrp}(1) |
all] state [enable|disable]
This command is used to configure the Layer 3 Control Filter setup of the Switch per port.
<portlist> - The user can enter a list of ports to be view here.
dvmrp | pim | igmp_query | ospf | rip | vrrp – Specify the L3 Control packet to be filtered.
all – Filter all L3 Control packets. .
state [enable|disable] – The user can set this command's state to be enabled or disabled.
Only Administrator-level users can issue this command.
This command is used to display the Layer 3 Control Filter setup of the Switch per port.
show cpu_filter l3_control_pkt {<portlist>}
This command is used to display the Layer 3 Control Filter setup of the Switch per port.
<portlist> - The user can enter a list of ports to be view here.
None.
3 C
ONTROL
278
41
P F
ACKET ILTERING