Pppoe Commands - D-Link DES-1228 Reference Manual

The PPPoE commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config pppoe circuit_id_insertion state
show pppoe circuit_id_insertion
show pppoe circuit_id_insertion ports
config pppoe circuit_id_insertion ports
Each command is listed, in detail, in the following sections.
config pppoe circuit_id_insertion state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To enable PPPoE circuit ID insertion:
DES-1228/ME:4#config pppoe circuit_id_insertion state enable
Command: config pppoe circuit_id_insertion state enable
Success.
DES-1228/ME:4#
show pppoe circuit_id_insertion
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[enable | disable]
{<portlist>}
<portlist> {state [enable | disable] | circuit_id [mac | ip | udf <string
32>]}(1)
Used to enable PPPoE circuit ID insertion operations on the switch.
config pppoe circuit_id_insertion state [enable | disable]
Used to enable PPPoE circuit ID insertion operations on the switch.
state [enable | disable] – The user can enable or disable this option
Only Administrator-level users can issue this command.
Used to display PPPoE circuit ID insertion operations on the switch.
show pppoe circuit_id_insertion
Used to display PPPoE circuit ID insertion operations on the switch.
None
None.
PPP
270
39
E C
O OMMANDS