D-Link DES-1228 Reference Manual page 140

Managed 10/100mbps metro ethernet switch
Hide thumbs Also See for DES-1228:
Table of Contents

Advertisement

config igmp_snooping
Restrictions
Example usage:
To configure IGMP snooping:
DES-1228/ME:4# config igmp_snooping default host_timeout 250 state enable
Command: config igmp_snooping default host_timeout 250 state enable
Success.
DES-1228/ME:4#
config igmp_snooping querier
Purpose
Syntax
Description
Parameters
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Note: The leave timer does not need to be configured as its action has no effect on the
IGMP snooping settings.
state [enable | disable] − Allows users to enable or disable IGMP snooping for the
specified VLAN.
Only Administrator-level users can issue this command.
Used to configure the time in seconds between general query transmissions, the
maximum time in seconds to wait for reports from members and the permitted packet loss
that guarantees IGMP snooping.
config igmp_snooping querier [ vlan_name <vlan_name 32> |all] {query_interval
<sec 1-65535> | max_response_time <sec 1-25> | robustness_variable <value 1-255>
|last_member_query_interval <sec 1-25> | state [enable|disable] }(1)
The config igmp_snooping querier command configures IGMP snooping querier.
<vlan_name 32> – The name of the VLAN for which IGMP snooping querier is to be
configured.
query_interval <sec 1-25> − Specifies the amount of time in seconds between general
query transmissions. the default setting is 125 seconds.
max_response_time − The maximum time in seconds to wait for reports from members.
The default setting is 10 seconds.
robustness_variable − Provides fine-tuning to allow for expected packet loss on a subnet.
The value of the robustness variable is used in calculating the following IGMP message
intervals:
• Group member interval − Amount of time that must pass before a multicast router
decides there are no more members of a group on a network. This interval is calculated as
follows: (robustness variable x query interval) + (1 x query response interval).
• Other querier present interval − Amount of time that must pass before a multicast router
decides that there is no longer another multicast router that is the querier. This interval is
calculated as follows: (robustness variable x query interval) + (0.5 x query response
interval).
• Last member query count − Number of group-specific queries sent before the router
assumes there are no local members of a group. The default number is the value of the
robustness variable.
• By default, the robustness variable is set to 2. You might want to increase this value if
you expect a subnet to be lossy.
last_member_query_interval − The maximum amount of time between group-specific
query messages, including those sent in response to leave-group messages. You might
lower this interval to reduce the amount of time it takes a router to detect the loss of the
last member of a group.
state − If the state is enable, it allows the switch to be selected as a IGMP Querier (sends
IGMP query packets). It the state is disabled, then the switch can not play the role as a
querier. Note that if the Layer 3 router connected to the switch provide only the IGMP
135

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Des-1228me

Table of Contents