Command
show stp mst_config id
Each command is listed, in detail, in the following sections.
enable stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable STP, globally, on the Switch:
DES-1228/ME:4#enable stp
Command: enable stp
Success.
DES-1228/ME:4#
disable stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable STP on the Switch:
DES-1228/ME:4#disable stp
Command: disable stp
Success.
DES-1228/ME:4#
config stp version
Purpose
Syntax
Description
Parameters
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
Used to globally enable STP on the Switch.
enable stp
This command allows the Spanning Tree Protocol to be globally enabled on the Switch.
None.
Only Administrator-level users can issue this command.
Used to globally disable STP on the Switch.
disable stp
This command allows the Spanning Tree Protocol to be globally disabled on the Switch.
None.
Only Administrator-level users can issue this command.
Used to globally set the version of STP on the Switch.
config stp version [mstp | rstp | stp]
This command allows the user to choose the version of the spanning tree to be
implemented on the Switch.
mstp – Selecting this parameter will set the Multiple Spanning Tree Protocol (MSTP)
globally on the Switch.
rstp − Selecting this parameter will set the Rapid Spanning Tree Protocol (RSTP) globally
on the Switch.
stp − Selecting this parameter will set the Spanning Tree Protocol (STP) globally on the
77