D-Link DES-1228 Reference Manual page 55

config snmp system_contact
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch contact to "MIS Department II":
DES-1228/ME:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-1228/ME:4#
config snmp system_location
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch location for "
DES-1228/ME:4#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DES-1228/ME:4#
config snmp system_name
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to enter the name of a contact person who is responsible for the Switch.
config snmp system_contact{<sw_contact>}
The config snmp system_contact command is used to enter the name and/or other
information to identify a contact person who is responsible for the Switch. A maximum of
128 characters can be used.
<sw_contact> − A maximum of 128 characters is allowed. A NULL string is accepted if
there is no contact.
Only Administrator-level users can issue this command.
Used to enter a description of the location of the Switch.
config snmp system_location {<sw_location>}
The config snmp system_location command is used to enter a description of the
location of the Switch. A maximum of 128 characters can be used.
<sw_location> − A maximum of 128 characters is allowed. A NULL string is accepted if
there is no location desired.
Only Administrator-level users can issue this command.
H Q 5 F
Used to configure the name for the Switch.
config snmp system_name {<sw_name>}
The config snmp system_name command configures the name of the Switch.
<sw_name> − A maximum of 128 characters is allowed. A NULL string is accepted if no
name is desired.
Only Administrator-level users can issue this command.
":
50