The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the VLAN Trunk:
DES-1228/ME:4#enable vlan_trunk
Command: enable vlan_trunk
Success.
DES-1228/ME:4#
disable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the VLAN Trunk:
DES-1228/ME:4#disable vlan_trunk
Command: disable vlan_trunk
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[<portlist>|all] state [enable|disable]
Used to enable the VLAN trunk function.
enable vlan_trunk
When the VLAN trunk function is enabled, the VLAN trunk ports shall be able to forward all
tagged frames with any VID.
None.
Only Administrator-level users can issue this command.
Used to disable the VLAN trunk function.
disable vlan_trunk
This command is used to disable the VLAN trunk function.
None.
Only Administrator-level users can issue this command.
VLAN T
RUNKING
240
35
C
OMMANDS