Port Security Commands - D-Link DES-1228 Reference Manual

The Switch's port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config port_security
ports
delete port_security
entry
clear port_security_entry
show port_security
enable port_security
trap_log
disable port_security
trap_log
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the port security:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[ <auth_portlist>| all ] { admin_state [enable | disable] | max_learning_addr <max_lock_no
0-64> | lock_address_mode [DeleteOnTimeout | DeleteOnReset | Permanent]}(1)
vlan_name <vlan_name 32> mac_address <macaddr> port <auth_port>
port <auth_portlist>
{ports <auth_portlist>}
Used to configure port security settings.
config port_security ports [ <auth_portlist>| all ] { admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-64> | lock_address_mode [DeleteOnTimeout |
DeleteOnReset | Permanent]}(1)
This command allows for the configuration of the port security feature. Only the ports
listed in the <auth_portlist> are affected.
<auth_portlist> − Specifies a port or range of ports to be configured.
all − Configure port security for all ports on the Switch.
admin_state [enable | disable] – Enable or disable port security for the listed ports.
max_learning_addr <max_lock_no 0-64> − Use this to limit the number of MAC addresses
dynamically listed in the FDB for the ports.
lock_address_mode [Permanent | DeleteOnTimout | DeleteOnReset] – Indicates the
method of locking addresses. The user has three choices:

Permanent – The locked addresses will not age out.

DeleteOnTimeout – The locked addresses will age out after the aging timer
expires (Aging Time is set using the FDB command).

DeleteOnReset – The locked addresses will not age out until the Switch has been
reset.
Only Administrator-level users can issue this command.
P S
ORT ECURITY
28
7
C
OMMANDS