Arp Commands - D-Link DES-1228 Reference Manual

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create arpentry
config arpentry
delete arpentry
show arpentry
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To create a static arp entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DES-1228/ME:4#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DES-1228/ME:4#
config arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
<ipaddr> <macaddr>
<ipaddr> <macaddr>
{[<ipaddr> | all]}
{ipif [System] | ipaddress <ipaddr> | static}
<value 0-65535>
Used to make a static entry into the ARP table.
create arpentry <ipaddr> <macaddr>
This command is used to enter an IP address and the corresponding MAC address into
the Switch's ARP table.
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address above.
Only Administrator-level users can issue this command. The Switch supports up to 255
static ARP entries.
Used to configure a static entry in the ARP table.
config arpentry <ipaddr> <macaddr>
This command is used to configure a static entry in the ARP Table. The user may specify
the IP address and the corresponding MAC address of an entry in the Switch's ARP table.
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address above.
Only Administrator-level users can issue this command.
192
26
ARP C
OMMANDS