D-Link DES-1228 Reference Manual page 257

enable lldp
Parameters
Restrictions
Example usage
To enable LLDP:
DES-1228/ME:4# enable lldp
Command: enable lldp
Success.
DES-1228/ME:4#
disable lldp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To disable LLDP:
DES-1228/ME:4# disable lldp
Command: disable lldp
Success.
DES-1228/ME:4#
config lldp message_tx_interval
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
and process the LLDP packets.
The specific function of each port will depend on the per port LLDP setting. For the
advertisement of LLDP packets, the switch announces the information to its neighbor
through ports. For the receiving of LLDP packets, the switch will learn the information from
the LLDP packets advertised from the neighbor in the neighbor table.
The default state for LLDP is disabled.
None.
Only Administrator-level users can issue this command.
Used to disable LLDP operation on the switch.
disable lldp
The switch will stop sending and receiving of LLDP advertisement packets.
None.
Only Administrator-level users can issue this command.
Used to change the packet transmission interval.
config lldp message_tx_interval <sec 5 - 32768 >
This interval controls how often active ports retransmit advertisements to their neighbors.
message_tx_interval − Changes the interval between consecutive transmissions of LLDP
advertisements on any given port. The range is from 5 to 32768 seconds. The default
setting is 30 seconds.
Only Administrator-level users can issue this command.
252