Network Monitoring Commands - D-Link DES-1228 Reference Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
config log_save_timing
show log_save_timing
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the packets analysis for port 7 of module 2:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
<portlist>
<portlist>
[cpu | ports {<portlist>}]
ports <portlist>
index <value_list X-Y>
<index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number>|
state [enable | disable]
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr>
| state [enable | disable]}
[<index 1-4> | all]
<index 1-4>
[time_interval <min 1-65535> | on_demand | log_trigger]
Used to display statistics about the packets sent and received by the Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and received by ports
specified in the <portlist>.
<portlist> − Specifies a port or range of ports to be displayed.
None.
N M
ETWORK
64
C
ONITORING
10
OMMANDS